More info or
buy here
|
|
How To Use These Links
We have extracted brief information about the page you will go to if you
click the link at the end of each paragraph.
-
Many people use salt in their ponds. I do not recommend it but the reason is to help prevent parasitic diseases that lead to complicated bacterial diseases. It is important not to overdose and if the intent is to remove parasites from individual fish then rather place the fish in another small temporary pond loaded with salt for a few minutes. Use about 2 lbs per 20 US gallons of pond water as a general treatment. As a short term soaking to treat individual fish use about 3 times as much salt as above. Adding pond start bacterial mixtures can do no harm especially at springtime. blanketweed in fish ponds
-
Save when you buy koi food or fish food. Check your koi fish food label. Do NOT waste money. Understand the specification on koi food and fish food packets and you will save considerable amounts of money and grow bigger koi fish more quickly. Do not believe everything you are told about koi food it might not be true. Check for yourself easily. Koi Food If a 5 kg bag of koi food contains 15% ash, 10% moisture and 3% fibre then 28% of the bags contents (amounting to a whopping 1.4 kg) is a total waste of money. http://www.practical-water-gardens.com/koifood.htm pond pump selection
-
Filamentous algae and blanket weed. Attached filamentous algae can be seen growing on the rocks of a waterfall or on the sides of the pond. The growth of filamentous algae results from high levels of nutrients, carbon dioxide and the catalyst, the suns energy. Methods of controlling filamentous algae include increased shade, reducing the frequency of fish feedings, practical water changes, and the use of chemicals or plecostomus (algae-eating fish) during the summer months. High pH levels suit algae growth of this kind. This is one reason chalk stream or spring creeks tend to have blanket-weed and are very clear. blanketweed in fish ponds
-
Not got a biological filter? Then all the microbial activity that happens in biological filters has to happen in the bottom of the pool. All the muck that falls has to be digested by bacteria down there. But with the advent of winter this activity slows right down at a time of year when the potential load is increased by falling autumn leaves. Any leaves that have found their way in to the pool need to be dredged out with a net. Leave the resulting muck to drain away on the side of the pool for 24 hours. This will give time for any wildlife to make its way back into the pool. using pond filters for clean ponds
-
Do not buy fish food with more than 10% ash in it unless you know why. Read the label. If no label BE CAREFUL of quality. Gold fish food or koi food bought in stick form is normally money wasted and offers no real benefit to the fish. It is the analysis of the food that is important not the physical shape. Gold fish food or koi food in stick form was developed before pellets could float - this is the reason gold fish food or koi food sticks were invented. pond pump selection
-
Bio filter starter bacteria ... Think carefully before buying any so called bacteria starter or bio starter. In general do not add anything to a pond unless you understand why you are doing it and are sure of the benefit to be gained. If no obvious, proven, financial or fish health benefit then Do Not Add to your pond. Many commercial pond products are a total waste of money and time. It is because many people do not have biofilters that products have been "invented" to compensate for this inadequacy. Manufacturers are quick to see opportunities to add to their turnover. biomedia for pond filters
-
UV light water filters, UV lamp changes & pond algae control. Pond volume, stock density and sunlight intensity is required to specify correctly the size of the Ultra violet (UV) light you need to prevent algae making your pond go green For a pond of around 250 gallons in full sun and highly stocked a 4 watt UV will do the job. This will also be big enough for a pond with very few fish and situated in the shade of 700 gallons. This assumes the UV comes equipped with a quartz tube to ensure the UV runs at peak efficiency. For a pond with average stocking an 8 watts UV will handle pond volumes up to around 1200 gallons depending upon the sun/shade situation. http://www.practical-water-gardens.com/artuvcapacity.htm uv maintenance, lamp changes
-
Sponges in pond pumps ... These days the best pumps do not have sponges inside the suction body. Such sponges are a source of major hassles especially in summer when they block up every couple of days and have to be removed. So long as you keep this type of pump away from heavy debris on bottom of pond (stand the pump on a brick for example) you will get away with removing the sponge permanently ... although such use would nullify the pump's guarantee. The sponge is there to protect the impellor form debris damage. fountain pumps
-
Pumps ... most small submersible pumps have impellors designed to turn in a single direction. This type normally have curved rotor blades for improved pumping efficiency. To make sure they do not start up in the wrong direction when you switch them on this type of rotor can only be turned by hand about 3/4 of a turn before it comes to a deliberate stop. If and when your pump suddenly stops pumping this is the first and easiest test to do to find out if the rotor needs changing or if something more serious is wrong with your pump. If the blades go round and round and round you probably just need a new rotor. pond pump flow rates
-
Pond volume measurement ... Measure the depth using a tape or stick. Using the pond pump measure how long it takes to fill say a 5 gallons container. Now pump water out of the pond for say 5 minutes Record the depth after pumping out water The pond's volume is then calculated as follows: S = depth of pond in inches or any unit before pumping starts D = inches or any unit of water pumped out of pond when pumping stops T1 = time to fill the container T2 = time pump was run to pump out water V = volume of container ..... Volume of pond = (S x V x T2) DIVIDED BY (D x T1) waterfall pumps
|
|
Never switch off your pond pump for more
than about 60 minutes
Make sure the delivery pipe from the
pond pump is not kinked
Must the UV be placed before the
biofilter?
A waterfall adds oxygen to a pond by
creating a large surface area
Submersible pond pumps can operate
against a closed valve
It is a good idea to pump out about 10%
of your pond water
Lighting in and around ponds creates a
brand new dimension
Sick and tired of looking at debris on
the bottom of your pond?
Do not feed more food than what you fish
can eat
Pond Links and Tips
|